SYMBIOS LOGIC 53C875J DRIVER FOR WINDOWS 7

Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type. Is this the right one to use? Contact Email us Tell us what you think. Thanks John, I’ll give the other driver a try tonight. See the ncrs 7D man page. You can still use the tar command to add or extract files to or from the tape in the drive. You can suppress these warnings by disabling tagged queuing in the ncrs.

Uploader: Mezshura
Date Added: 14 November 2005
File Size: 39.13 Mb
Operating Systems: Windows NT/2000/XP/2003/2003/7/8/10 MacOS 10/X
Downloads: 70655
Price: Free* [*Free Regsitration Required]

In case it might be a problem with the tape drivers, here’s that info as listed in device mangler: All forum topics Previous Topic Next Topic. symbios logic 53c875j

The opinions expressed above are the personal opinions of the authors, not of Hewlett Packard Enterprise. The olgic driver supports at least Revision 4 of the 53C chipset.

Is symbios logic 53c875j the right one to use? On some Pentium motherboards Intel NX chipset using P90 or slower processors, ncrs hangs and this message is displayed on the console:.

Previous revisions were pre-release versions of the chip, so there might still symbiod a few in circulation.

Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.

Motherboard Test Report

symbips Proliant running Windows Server yes, it’s true – 2x PII and I’m getting strange behavior media incorrectly identified from both tape drives, one connected to each of the two Symbios Logic 53C controllers on the system. Symbios logic 53c875j some early PCI systems with the 53C chip on the motherboard, the interrupt pin on the chip is not connected.

Upgrading the motherboard BIOS, the add-in symbios logic 53c875j, or both may prevent these conflicts.

Hi, I have an old? Hi Jim, Termination is important so make sure it’s good.

Such a system cannot be used with Solaris software. I’ve found that some symbios logic 53c875j systems are not fussy at all and others are very fussy on the Proliant Contact Email us Tell us what you think. These configurations are not supported. In these instances, the 53c875 recovers and the tape drive remains usable.

SYMBIOS / LSI LOGIC 53C875J SINGLE CHANNEL 32BIT PCI WIDE ULTRA SCSI HOST BUS ADAPTER

If the DOS partition isn’t created, the system won’t reboot after Solaris installation. It might not be a driver problem though, the is not LVD! See the symbios logic 53c875j 7D man page. So there must be a termination problem I suppose, though I have no idea how to fix it I have also use the generic windows scsi symbios logic 53c875j too and been able to get it to work sometimes with certain devices.

CONFIG_SCSI_SYM53C8XX_2: SYM53C8XX Version 2 SCSI support

Create at least a 1-cylinder DOS partition starting at cylinder 0. You can symbios logic 53c875j these warnings symbios logic 53c875j disabling tagged queuing in the ncrs. Will it perhaps fix the issues with the tape drives? Do not attempt to connect wide targets to the narrow connector of the cards listed as supporting narrow disks.

PCI\VEN_ – LSI Logic / Symbios Logic | Device Hunt

By using this site, you accept the Terms of Use and Rules of Participation. You can still use the symbios logic 53c875j command to add or extract files to or from the tape in the drive.

On some Pentium motherboards Intel NX chipset using P90 or slower processors, ncrs hangs and this message is displayed symbios logic 53c875j the console: Hewlett Packard Enterprise International. Do you need help with your HP product? Thanks John, I’ll give the other driver a try tonight. I’ve even went so symbios logic 53c875j as to dismantle the server and the tape drives a clean them of dust that was a bunch, yuk.

Begin typing your search term above and press enter to search. Press ESC to cancel.

Back To Top